AJ Engineering

Go to content

Main menu

Knife Drives

Is your older sheeter having trouble holding consistent sheet length?  
Make-Ready taking too long?

Having trouble finding the spare parts or service?  

If so, a Knife Drive Upgrade may be just what you need.

Starting at $20,000, a Knife Drive Retrofit can help you dramatically increase production, while at the same time, increasing sheet quality.  A new Inverter Drive and Motor on the Draw Roll acts as the Master Drive and a separate drive on the Knife Cylinder acts as the Follower. What used to take up to an hour can literally be done in seconds.

We use Danfoss FC302 Drives in conjunction with AB's Micrologix PLC and Exor's ePad05 Operator Interface.  Their dependable performance and good names in the industry give us the confidence we need in order to offer you a product worthy of AJ Engineering's backing.   Dr
op us a line to get detailed information on this great upgrade.  

Customer referrals are available upon request.

Back to content | Back to main menu